Brass - Pop Filter Only
The Ohma Pop Filter snaps directly into the bottom screen slot of your Ohma microphone, giving you cleaner close-mic capture, consistent placement, and a setup that stays simple.
Want the full setup instead?
Get the Motif Stainless Condenser and this Pop Filter together and save $20.
Shop the Bundle →
Made for Voices
Built for singers, podcasters, voiceover artists, streamers, and anyone recording vocals up close.
Camera-Ready, Studio-Grade
Designed to look as good on camera as it sounds, thanks to a dual-layer fabric that cuts plosives without dulling your tone the way cheaper filters do.
Consistent placement every time
Because the Pop Filter snaps into the mic, the spacing is built in. You do not have to guess where the filter should sit or keep adjusting it between takes.
No gooseneck drama
Traditional pop filters can sag, drift, twist, or slowly migrate into the wrong place. This one snaps in and stays where it belongs.
Cleaner close-mic capture
Helps reduce plosives, mouth wind, and moisture before they reach the capsule or ribbon.
Tone-conscious design
Built to control air movement without smearing the sound, dulling the top end, or making the mic feel covered.
Built for the Ohma system
Designed for Ohma Ribbon and Ohma Condenser microphones only. It is not trying to be universal, which is why it fits the mic so cleanly.
Each Pop Filter comes in a sturdy box with two Ohma 1.21 mm guitar picks for screen swapping and a kickstand, so the filter can stand upright on your desk whenever it's off the mic.
It snaps into place using the magnetic screen system built into Ohma microphones, taking the spot of the bottom logo screen. Just use the supplied guitar pick to gently pop off the logo screen, then snap the Pop Filter in where the logo used to be.
Why an Ohma Pop Filter?
One magnet, one motion
Consistent placement every time
No gooseneck drama
Cleaner close-mic capture
Tone-conscious design
Dual-layer acoustic fabric
What People Are Saying
One Filter, Every Setup
Singers
Streaming
Podcasts
Not Just a Pretty Mic
Pop Filter FAQ
-
No. The Ohma Pop Filter is designed specifically for Ohma Ribbon and Ohma Condenser microphones.
-
It replaces the bottom logo screen and snaps into place using the magnetic screen system built into Ohma microphones.
-
Yes. It is especially useful for podcasting, voiceover, and spoken-word recording because it keeps plosives under control without adding a large clamp-on filter in front of the mic.
-
Yes. It sits close to the microphone and does not require a gooseneck, clamp, or external arm, which keeps the setup cleaner on camera.
-
The standard black Ohma Pop Filter is made from vacuum-molded durable material similar to ABS.
-
Yes, but painted-to-match metal pop filters are currently available only through the Ohma Mic Builder.